ERIE 1000 Ton Hydraulic Forging Press,
S/N 25-8863, NEW IN 1989
SPECIFICATIONS:
Capacity-Pressing………………………………………………………………………. 1000 Tons
Bed Area (L-R x F-B)…………………………………………………………………… 48” x 48”
Top & Bottom Bolster Thickness…………………………………………………….. 6”
Daylight Between Bolsters……………………………………………………………… 72”
Stroke……………………………………………………………………………………………… 26”
Shut Height……………………………………………………………………………………. 46”
Main Ram diameter-Single Acting…………………………………………………. 26”
Side Cylinders Dia. (2)- Commercial……………………………………………… 5” x 3”
Top Ejector Capacity………………………………………………………………………. 15 Tons
Top Ejector Stroke………………………………………………………………………….. 6”
Bottom Ejector Capacity…………………………………………………………………. 15 Tons
Bottom Ejector Stroke…………………………………………………………………….. 8”
Maximum Height Under Crane………………………………………………………. 24’
Tank Area……………………………………………………………………………….. 60” x 120”
Foot Print……………………………………………………………………………………. 4’ x 7’
PRESS OPERATING SPEEDS:
Advance…………………………………………………………………………………………. in
Pressing w/Accumulator System (6” working stroke available)… 600 in/min (adj)
Return…………………………………………………………………………………….. 600 in/min
Top Ejector Extend………………………………………………………………….. 300 in/min
Bottom Ejector Extend……………………………………………………………… 300 in/min
HYDRAULIC PUMPING UNIT:
1-Axial Piston Pump
1-Double Vane Pump
1-Accumulator System
* 1-200 HP Electric Motor @ 1200 RPM, TEFC Double Shaft (Kaiser to furnish)
* Erie Press Systems requires certified print to design Pumping
unit S.A.P. –P.D.Q.
1-Full Voltage Motor Starter
Electrical Characteristics……………………………………………………………. 3/60/480
Press Operating Pressure…………………………………………………………….. 4500 PSI
THEORETICAL TIME CYCLE:
Advance 14”……………………………………………………………………………….. 1.4 Sec
Press 4”……………………………………………………………………………………… 0.4 Sec
Return 18”……………………………………………………………………………….. 1.8 Sec
Valve Response Time…………………………………………………………………. 1.5 Sec
Acceleration & Deceleration…………………………………………………………. 1.5 Sec
TOTAL……………………………………………………………………………………….. 6.6 Sec
Theoretical Strokes Per Min………………………………………………………… 6 Stk/Min
(Based on Accumulator Recovery)
CONDITION: Very Good-A well maintained press that was last used to forge
aluminum parts. Currently partially disassembled and in storage.
LOCATION: Michigan, USA
Stk#2481CE